The 7703DA16-RF 1x16 Active Splitters provide amplification and distribution of RF signals from 40MHz to 3GHz. They handle any RF input modulation format and provide 16 isolated outputs for further signal distribution. Typical applications include amplification and distribution of 950MHz-2150MHz L-Band and 70MHz-140MHz IF signals. Monitoring of RF input power, card status and control of gain/attenuation is provided remotely via VistaLINK® capability on the this versions. The 7703DA16-RF occupy two card slots and can be housed in the 1RU 7801FR frame which holds up to four single or two dual slot modules, the 3RU 7800FR frame which has a 15 slot capacity, the portable 3RU 350FR frame which has a 7 slot capacity, or a standalone enclosure which holds a single module.
Low noise amplification and distribution of RF signals from 40MHz to 3GHz
Wideband frequency response for use with L-Band, 70/140MHz IF and off-air DTV signals
Wide dynamic range (-10 to -60dBm)
Output gain of -10dB to +20dB adjustable in 1/2dB steps
AGC mode with adjustable target level
Protocol independent - handles all modulation formats
Input RF signal strength monitoring
Fully hot-swappable from front of frame
Comprehensive signal and card status monitoring via four digit card edge display or remotely through SNMP and VistaLINK®
VistaLINK® capable for remote monitoring via SNMP (using VistaLINK® PRO) when installed in 7800FR frame with a 7700FC VistaLINK® Frame Controller
Spec Sheet available - Yes
RF Input Connector:
BNC per IEC 61169-8 Annex A (F-Type optional)
RF Input Return loss:
> 15 dB
RF Input Frequency Range:
40MHz to 3GHz
RF Input Power Range:
-10 to -60 dBm
RF Input Current Limit:
400 mA
RF Input LO Control:
22 kHz on/off
RF Output Connector:
BNC per IEC 61169-8 Annex A (F-Type optional)